Filter
Top Products
4
Insert the cartridge in the rough. The locator tab
on the cartridge goes straight into the notch in the
rough*.
Turn on the water supplies. Grasp the stop unit
portion of the cartridge and turn it.
If there is a leak around the cartridge, turn the
supplies off, and remove the cartridge. Confirm
that the sealing gasket from the flushing plug was
removed.
Reinstall the cartridge. Turn the stop unit.
If the unit continues to leak, contact Hansgrohe
Customer Service for a replacement cartridge.
The positioning pin on the back of the cartridge goes straight into the hole in the rough.
Use the reserved screws to connect the cartridge retainer plate to the rough. Tighten the
screws evenly, using a manual screwdriver, in a cross-wise pattern. Do not overtighten
the screws.
English
*Note: The earlier version of
the ThermoBalance I rough does
not have the notch for the locator
tab. See page 6 for cartridge
modification instructions.
Perform the following test to check for damage to the ceramic
plates inside the stop unit.
Failure to correctly perform this test can result in possible water
damage.
locator tab
notch
positioning
pin hole
stop unit