Filter
Top Products
XIV. EQUIPMENT MAINTENANCE
Your Model G1024 Shaper requires very little maintenance. A thorough cleaning, now and again, will
increase the machine’s durability and efficiency, by removing dust and grime that can gum up mov-
ing parts. Sharp cutting surfaces are essential for top performance. If you find that the machine cuts
less efficiently than usual, inspect the cutters and repair or replace them as necessary. An occa-
sional application of Top-Cote
®
protective spray will keep the shaper table and other bare metal parts
from rusting and pitting. Remember: When performing maintenance or repairs on this, or other shop
equipment, always disconnect the power supply.
A. LUBRICATION
The Model G1024 features factory-sealed bearings. A sealed bearing requires no lubrication during
its lifetime.
Should a bearing fail, your shaper will probably develop a noticeable rumble, which will increase
when the machine is put under load. If allowed to get worse, overheating of the journal containing
the bad bearing could occur. If the bad bearing is not replaced, it will eventually seize – possibly
doing damage to other parts of the machine. Bearings are standard sizes and can be replaced
through Grizzly.
The only parts on this machine that require periodic lubrication are the ways where the cartridge
slide rides on the elevation housing and where the worm gear and bushing are located. Use a light
grease or anti-seizing compound on the ways and worm gear and give the shaft mount a shot of light
oil. The frequency of lubrication depends on the amount you use the shaper. As a habit, inspect the
machine at least one a month.
B. V-BELT MAINTENANCE
Avoid getting grease or oil on the V-belt or pulleys.
Check the V-belt, as part of your monthly inspection, for proper tension and belt condition. Cracking
and glazing could result in belt failure. Replace the belt if such conditions appear.
XV. CLOSURE
The following pages contain the directory of parts for your Model G1024 Shaper. We have also
included a wiring diagram and instructions for using the optional Router Bit Spindle for your conve-
nience.
Please feel free to write or call us if you have any questions about the machine or the manual.
Thank you again for your business and continued support. We hope to serve you again soon.
- 27 -