Filter
Top Products
SPECIFICATIONS
SPECIFICATIONS - 41
NOTE: The stored battery should be recharged every 90
days.
Charge the battery.
IMPORTANT: Avoid Damage! Prolonged exposure to
sunlight could damage the hood surface. Store ma-
chine inside or use a cover if stored outside.
Store the vehicle in a dry, protected place. If vehicle is
stored outside, put a waterproof cover over it.
Removing Machine From Storage
Check tire pressure.
Check engine oil level.
Check battery electrolyte level, if your battery is not
maintenance free. Charge battery if necessary.
Install battery.
On gas engines: Check spark plug gap. Install and
tighten plugs to specified torque.
Lubricate all grease points.
Open fuel shut-off valve, if your machine is equipped.
Run the engine 5 minutes without the mower or any at-
tachments running to allow oil to be distributed through-
out engine.
Be sure all shields and guards or deflectors are in
place.
Assembly
Connect Handles
The handles are disconnected and rotated forward dur-
ing assembly to allow for proper fitment into the shipping
container.
Rotate the handles up.
A
B
C
Connect the pump control arm (C) to the handle
weldment by inserting the adjustment block (A) into the
handle weldment and securing with the hairpin clip (B).
Set the speed control bar to desired speed and lock.
10.
11.
1.
2.
3.
4.
5.
6.
7.
8.
9.
1.
2.
3.
Check Hydraulic Oil Level
A
B
Clean area around dipstick cap (A).
Remove dipstick cap (A). Wipe dipstick clean.
NOTE: Do not tighten dipstick cap when checking oil
level.
Insert dipstick in filler neck (B). Do not tighten cap.
Remove dipstick. Check oil level on dipstick. Oil level
should be between the ADD and FULL marks on dip-
stick.
If oil is level is below ADD mark, fill to proper
level.
If oil level is above FULL mark, drain to proper
level.
Insert dipstick. Tighten cap.
Check Engine Oil Level
�
Clean area around dipstick cap (A).
Remove dipstick cap (A) from tube. Wipe dipstick
clean.
NOTE: Do not tighten dipstick cap when checking oil
level.
Insert dipstick in tube. Do not tighten cap.
Remove dipstick. Check oil level on dipstick. Oil level
should be between the ADD and FULL marks.
1.
2.
3.
4.
•
•
5.
1.
2.
3.
4.