Filter
Top Products
Part No. 82595 Genie Z-45/25 DC & Genie Z-45/25J DC 23
Operator's ManualSecond Edition · First Printing
Drive Enable
Light on indicates that the boom
has moved just past either non-
steer wheel and the drive
function has been interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Controller Fault Indicator
Light On
If the controller fault indicator light is on, push in
the red Emergency Stop button, wait a few
seconds and pull out the red Emergency Stop
button to reset the system.
If the light stays on, tag and remove the machine
from service.
Platform Overload Indicator
Light (if equipped)
Light flashing indicates the
platform is overloaded and no
functions will operate.
Remove weight from the platform
until the light goes off.
OPERATING INSTRUCTIONS
Machine Not Level Indicator
Light (if equipped)
Light on indicates the machine is not
level. The tilt alarm will be sounding
when this light is on. Move the
machine to a firm level surface.
Fall Protection
Personal fall protection equipment (PFPE) is
required when operating this machine.
All PFPE must comply with applicable
governmental regulations, and must be inspected
and used in accordance with the PFPE
manufacturer’s instructions.
After Each Use
1 Select a safe parking location—firm level
surface, clear of obstruction and traffic.
2 Retract and lower the boom to the stowed
position.
3 Rotate the turntable so that the boom is
between the non-steer wheels.
4 Turn the key switch to the off position and
remove the key to secure from unauthorized
use.
5 Chock the wheels.
6 Charge the batteries (if necessary).