Filter
Top Products
18 Genie Z-45/25 DC & Genie Z-45/25J DC Part No. 82595
Operator's Manual Second Edition · First Printing
FUNCTION TESTS
Test Drive and Braking
24 Press down the foot switch.
25 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the drive
chassis, then come to an abrupt stop.
26 Slowly move the drive control handle in the
direction indicated by the yellow arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Test Limited Drive Speed
27 Press down the foot switch.
28 Raise the primary boom approximately
2 feet / 61 cm.
29 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not
exceed 1 foot / 30 cm per second.
30 Lower the primary boom to the stowed position.
31 Raise the secondary boom approximately
2 feet / 61 cm.
32 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 foot / 30 cm per second.
33 Lower the secondary boom to the stowed
position.
34 Extend the primary boom approximately
1 foot / 30 cm.
35 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 foot / 30 cm per second.
36 Retract the boom.
If the drive speed with the primary boom raised, the
secondary boom raised or the primary boom
extended exceeds 1 foot / 30 cm per second,
immediately tag and remove the machine from
service.