Filter
Top Products
Troubleshooting
Owner’s Manual for Stationary Emergency Generators 51
12. Press MANUAL on the control panel to start the engine. A blue LED illuminates to confirm that the system is in
the MANUAL mode.
13. Allow the engine to run until it is reaches normal operating temperature. Check for leaks while the engine is run-
ning.
14. Press OFF on the control panel. A red LED illuminates to confirm that the system is in the OFF mode.
15. Install left and right side access panels. See Subsection 5.2 —Access Panels.
16. Turn on utility power to the transfer switch.
17. Press AUTO on the control panel. A green LED illuminates to confirm that the system is in the AUTO mode.
18. Reset the time and date.
19. Close the viewing window.
6.5 — Attention After Submersion
Do NOT start and operate the generator if it has been submerged in water. Have a Dealer thoroughly clean, dry, and
inspect the generator following any submersion. If the structure (home) has been flooded, it should be inspected by a
certified electrician to ensure there won’t be any electrical problems during generator operation or when utility power is
returned.