Filter
Top Products
Specifications
10 Owner’s Manual for Stationary Emergency Generators
Serious injury, including death, or damage will occur if not configured properly. Consult an Authorized
Dealer with any questions.
2.7.2— Change Fuel Selection
Failure to convert both the hardware and software will result in decreased performance and an increase in
emissions, which is a violation of Environmental Protection Agency (EPA) regulations. It is the responsibility
of the installer to make sure that only the correct recommended fuel is supplied to the generator fuel system.
Thereafter, the owner/operator must ensure that only the proper fuel is supplied.
1. Once fuel regulator is converted to desired fuel type call 888-9ACTIVATE for the control panel password. This
fuel selection conversion is required to be password protected by EPA regulations.
2. Access the control panel located behind the viewing window at the rear of the unit.
3. From the Home screen, press ESCAPE to display the Main Menu.
4. Navigate the software using UP ARROW, DOWN ARROW, ENTER and ESCAPE. For more detailed informa-
tion, see Subsection 4.3 —Menu Navigation.
2.8 — Battery Requirements
2.8.1— Battery Charger
A 2.5 amp battery charger is integrated into the control panel module. It operates as a “Smart Charger” which ensures
output charging levels are safe and continuously optimized to promote maximum battery life.
2.9 — Corrosion Protection
Periodically wash and wax the enclosure using automotive type products. Frequent washing is recommended in salt
water/coastal areas.
Group 26, 12 Volt 1.5L, 2.4L Engines: For areas where temperatures regularly drop below 32° F (0° C).
NOTE: Battery dimensions (L x W x H) for Group 26 battery must not exceed 8-3/16" x 6-13/16" x 7-3/4"
(208mm x 173mm x 197mm).
Group 24F, 12 Volt 5.4L Engine: For areas where temperatures regularly drop below 32° F (0° C).
NOTE: Battery dimensions (L x W x H) for Group 24F battery must not exceed 10-3/4" x 6-13/16" x 9"
(273mm x 173mm x 229mm).
*