Filter
Top Products
1.1 UNPACKING
Remove all packaging material.•
Remove separate accessory box.•
Remove carton off the generator.•
1.1.1 ACCESSORY BOX
Check all contents (Figure 1). If any parts are missing or damaged
locate an authorized dealer at 1-888-775-6937.
Contents include:
1 – Axle (secured to frame) • Oil Filter•
2 – Wheel Spacers • Air Filter •
2 – Hair Pins • Spark Plugs•
2 – Wheels • • Shop Towel
1 – Frame Foot • • 2 – Large Washers
2 – Carriage Bolts • 2 – • Small Washers
2 – Vibration Mounts • • Oil Funnel
4 – Flange Nuts • • 2 – Hex Head Bolts (long)
2 – 1 Quart SAE 30 Oil Bottles• • 2 – Hex Head Bolts
12 Volt Adaptor Plug Charger • (short)
2 Spacers or 4 Large Washers•
Figure 1 – Accessory Box
1.2 ASSEMBLY
Read entire Owner's Manual before attempting to assemble or
operate the generator. The generator requires some assembly
prior to using it. If problems arise when assembling the generator,
please call the Generator Helpline at 1-888-775-6937.
1.2.1 ASSEMBLING THE WHEEL KIT AND FRAME FOOT
The wheel kit is designed to greatly improve the portability of the
generator. You will need the following tools to install the wheel kit:
1/2" (13mm) wrench and a socket wrench with a 1/2" (13mm)
socket.
NOTE:
The wheel kit is not intended for over-the-road use.
Refer to Figure 2 and install the wheel kit and frame foot as •
follows:
Slide the Axle through the Wheel, • Large Washer and the Frame.
Note orientation of wheel.
Install the Hair Pin to the Axle to secure the wheel. Repeat for •
the opposite side.
Secure the Vibration Mounts to the Frame Foot with the included •
hardware.
To install the Frame Foot, install the bolts though the Washers, •
Frame and Frame foot. Secure with the locking nuts.
Figure 2 – Wheel and Foot Assembly
4
General Information