Filter
Top Products
Not for
Reproduction
35
Wireless Monitor Operation
1. Remove battery access cover (C) on back of monitor
and install 2 AA batteries. (Observe correct battery
polarity which is embossed in the bottom of the
battery compartment). Replace battery access cover.
2. The wireless monitor does not have an on/off switch.
When batteries are installed correctly, the GENERATOR
READY green LED light will flash once every 7 seconds
indicating the status of the generator.
NOTICE If communication does not begin upon placing the
generator in AUTO, installing batteries, and pressing System
Update, the monitor may need to be re-linked. To link, follow
Steps 3 through 6.
DEALER NAME
DEALER
PHONE
generator power
service needed
generator ready
system updat
e
1 low battery voltage
2 low uid level
3 under/over voltage
4 engine does not start
part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
5 low frequency
6 engine overspeed
7 high temperature
8 transfer switch
# of flashes service needed
NOTICE The wireless monitor was linked to the generator at
the factory. Communication will begin upon the installation
of the batteries and the generator being placed in AUTO
mode. You may need to press System Update one time.
Antenna Placement
The wireless monitor includes an antenna, that must be
connected during the generator installation process.
1. Lift roof to the open position.
2. Carefully remove tape from roof to insert antenna
upright.
3. Secure antenna to roof with the flange nut.
A
A