Filter
Top Products
Not for
Reproduction
25
System Control Panel
The generator control board, located inside the generator,
under the roof, is shown below. Brief descriptions of the
controls used during installation are:
A
‑ Menu/Programming Navigation Buttons — See Menu
section for details
B
‑ Mini USB Port — Authorized Dealer Service Use Only
C
- Generator Operation Control Buttons —
•“AUTO” Normal operating position. Press and hold button
to put unit into Automatic mode. If an utility power
outage is sensed, the system will start the generator.
When utility power is restored, AUTO lets the engine
stabilize internal temperatures, shuts o the generator,
and waits for the next utility outage.
•“OFF” Turns o running generator, prevents unit from
starting, and resets any detected faults.
OFF must be pressed and held for more than 5 seconds in
order to reset service codes.
•“MANUAL” Used to manually start the generator.
‑ “AUTO” LED — LED will light when unit is placed into
AUTO mode. LED will blink if exercise cycle is not set or
set to OFF.
D
– 15 Amp Fuse — Protects the generator DC control
circuits. If the fuse has ‘blown’ (melted open) or was
removed, the engine cannot crank or start. Replace the
fuse using only an identical ATO 15A fuse. One spare
fuse is supplied with the unit.
E
‑ Cover — This protective cover must be opened to
access the fuse and the USB port.
F
‑ Digital Display — Displays generator mode, menu
options, service codes, and service engine indicators
More information may be found in Controls in the
operator’s manual.
ok
menu
esc
auto
off manual
A
B
C
D
F
E
*
*