Filter
Top Products
- 31 -
5.2 ADJUSTMENTS
5.2.1 Cutting height and anti-scalp roller adjustment.
WARNING
POTENTIAL HAZARD
♦ When the two front support rod hairpins are removed
from the mower deck, the weight of the tractor section
may cause the front frame to rise suddenly
WHAT CAN HAPPEN
♦ If the unit rises suddenly, injury may occur.
HOW TO AVOID THE HAZARD
♦ Securely hold down the front of the unit when the front
support rod hairpins are removed.
a) Stop engine and wait for all moving parts to stop.
b) Install hairpin clips in the holes for the desired cutting height (See Figure 9).
IMPORTANT: To maintain correct cutting height and rake, check the
following for proper adjustment.
1. The front and rear hairpins are in the same holes with the proper
spacers under the hair pins (See Figure 9).
2. The tire pressures are set as directed in Section 5.1.12.
3. The length of the rear deck support link assemblies should average
6.89” (approximately 6 7/8”) (17.5 cm) from the center of the ball
joint to the center of the furthest hole (See Figure 9).
NOTE: All (4) pins must equally support the weight of the deck.
Adjustment in the length of the rear deck support assemblies may be
necessary. If one side is longer than 6.89” (17.5 cm), than the opposite
side must be shorter by the same amount.
FIGURE 9
CUTTING HEIGHT ADJUSTMENT