Filter
Top Products
- 14 -
FIGURE 1
UPPER HANDLE MOUNTING
3.9 Route the throttle cable along the right side of the upper handle, under the fuel tank
support, and position the cable on the left side of the engine.
Attach throttle cable to engine:
a) Position the throttle control lever (located on console) ¼” (6mm) from the upper end
of the slot.
b) Attach inner wire of the throttle cable to the top hole in the throttle control lever
(See Figure 2).
c) Loosen the clamp, place the cable behind it, and pull on the cable to move the
throttle linkage to the full throttle position. Tighten the cable clamp screw.
FIGURE 2
SPEED CONTROL
(THROTTLE CABLE HOOK-UP)
3.10 Connect the PTO engagement linkage (See Figure 3). Loosen jam nut and
remove turnbuckle from lower linkage. Screw turnbuckle onto both upper and
lower linkages simultaneously. Note that threads on upper linkage are left hand.
See 5.2.2 for linkage adjustment.
Note: Handles have the drive lever linkage on the inside of the blade
engagement lever tab and the hairpin on the outside.
FIGURE 3
PTO ENGAGEMENT LINKAGE