Filter
Top Products
- 28 -
5.1.13 Inspect Belt wear.
Service Interval: 40 hrs.
a) Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s).
b) Remove deck support belt shield to check mower deck drive belt condition.
c) Look under engine deck to check the pump drive and clutching belt
condition.
5.1.14 Inspect PTO Clutching Belt Tension
.
Service Interval: Check every 2 hrs. for first 8 hrs. operation then check
every 40 hrs. thereafter.
a) Stop engine and wait for all moving parts to stop.
b) Engage PTO lever.
c) Look through the round hole in the left rear corner of the engine deck to
inspect blade clutching belt tension. Bolt on blade engagement linkage
bellcrank and indicator arm should align within 1/16” (.16 cm) (See Figure
13). Refer to section 5.2.2 for adjustment.
5.1.15 Lubrication
Service Interval: Refer to Chart.
a) Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s).
b) Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose
gun grease.
Refer to the following chart for fitting locations and lubrication schedule.
GREASE LUBRICATION CHART
FITTING
LOCATIONS
INITIAL
PUMPS
QUANTITY
36” 48” 52”
SERVICE
INTERVAL
1. Caster Wheel Bearings 12 2 2 2 8 hours
2. Caster Pivots 2 2 2 2 8 hours
3. PTO Engagement Bellcrank 1 1 1 1 40 hours
4. Idler Pivot (Pump Drive) 2 1 1 1 Yearly
5. Clutch Arm Pivot 1 1 1 1 40 hours
6. Mower Deck Idler Pivots 2 1 1 1 Yearly
7. Pump Control Bearings 2 2 2 2 40 hours
No. 4 (Idler Pivot)
Located Under Engine Deck
No. 5 (Clutch Arm Pivot)
Located Under Engine Deck
c) Lubricate pivot points with a spray penetrating
lubricant as directed below.