Filter
Top Products
Pr o Th a T c h aT T a c h m e n T
oP e r a T o r 's ma n u a l
9
A
B
C
D
4. Install and seat lower drive shaft end (end with fender/wheel as-
sembly into gear housing shaft mount. Make sure grass guide (D)
is facing down toward the ground.
5. Rotate and align hole in drive shaft housing with gear housing
shaft hole. Install and tighten alignment screw (A) with 4 mm hex
wrench.
6. Tighten gear housing shaft mounting bolt (B) with 5 mm hex
wrench.
7. Check for proper inner ex cable (C) engagement into gear hous-
ing adaptor. If ex cable extends out of drive shaft then cable is
not properly engaged. Rotate and push cable end until lower cable
end slides into place in gear housing adaptor. Cable end will recess
approximately 16 mm (5/8 in.) into drive shaft.
f r o n t j-h a n d l e a s s e m b l y
Tools Required: 10 mm Open End Wrench
Parts Required: Pro Attachment Series or Split Boom Upper Shaft
and Power Head
1. Remove original front handle assembly. Assemble handle parts
with fasteners and store in a safe place for future application with
other attachments.
2. Remove two (2) J-Handle bracket bolts (A) with 10 mm wrench.
3. Install J-Handle assembly with handle grip on the left side (viewed
from the operator's position) onto the upper drive shaft. Lightly
snug bolts (A) to temporarily hold handle in place.
A
A