Filter
Top Products
14
Drive Shaft (Lower)
IMPORTANT
Lower and upper drive shaft must be lubricated with ECHO
®
LUBE
TM
grease every 25 hours of operation, otherwise drive shaft
assembly overheating and failure can result.
1. Remove gear housing locator screw (A).
2. Loosen gear housing mounting bolt (B).
3. Pull gear box from drive shaft housing.
4. Pull exible cable from the drive shaft housing, wipe clean and
re-coat with a thin coating [15 ml (1/2 oz.)] of grease
5. Slide the exible cable back in the drive housing. DO NOT get
dirt on the ex cable.
6. Position lower drive shaft (end without safety decal) into gear
housing shaft mount.
7. Align hole in drive shaft housing with gear housing shaft hole
(C) and seat lower drive shaft end into gear housing shaft mount.
Install and tighten locator screw (A).
8. Tighten gear housing mounting bolt (B).
C
t I n e r e p l a c e m e n t
Level 2.
Tools Required: Vise Grip, 10 mm, 13 mm Open End Wrench
Parts Required: Thatching spring (P/N 61004725560), Screw (P/N
88995325560), plastic tube (P/N 21001325560)
Bent or broken tines should be replaced before operation for best det-
hatching efciency.
WARNING
Never replace tines with engine running. Tines are sharp, wear
gloves to protect your hands when replacing them.
A
B