Filter
Top Products
16
st o r a g e
1. Clean dethatcher attachment with a bristle brush and rinse with
clear water.
IMPORTANT
Do not immerse this attachment in water. Water will enter gear
housing and damage gears, bearings and seals.
2. Apply thin coating of oil to metal parts to prevent rust.
3. Lubricate lower shaft assembly with grease. (Refer to Lubrication
instructions on page 13.)
4. Store ProThatch Attachment in a dry place out of reach of children
with lower shaft housing in a horizontal or vertical postion to pre-
vent grease loss from open shaft end.
sp e c I f I c a t I o n s
MODEL ---------------------------------------------------- PRO THATCH ATTACHMENT
Shaft Length ------------------------------------------------ 928 mm (36.5 in.)
Attachment Width ----------------------------------------- 565 mm (22.2 in.)
Attachment Height ----------------------------------------- 403 mm (15.9 in.)
Weight ------------------------------------------------------- 9.6 kg. (21.14 lb.)
Drive Shaft -------------------------------------------------- 6.35 mm (0.25 in.)
Rotating Direction ----------------------------------------- Away from the operator viewed from the rear
Dethatcher Head ------------------------------------------- Left and right reels mounting 22 tines each, totaling 44 tines
Tines --------------------------------------------------------- 3mm (.19 in.) spring steel
Combing Width -------------------------------------------- 571 mm (22.5 in.)
Lubrication-------------------------------------------------- Lithium Base Grease
Gear Reduction Ratio ------------------------------------- 42.75 : 1
Dethatcher Operating (RPM)----------------------------- 210
Engine Wide Open Throttle (RPM) w/attachment ---- 7,700 - 8,500