Filter
Top Products
14
SECTION II. OPERATION
WARNING
RECEIVE INSTRUCTION - Read the
operator’s manual. Learn to operate this
machine SAFELY. Don’t risk INJURY or
DEATH.
1. Before starting the engine or beginning
operation, be familiar with the controls. The
operator must be seated, the PTO switch in
the “OFF” position and the brake pedal fully
depressed.
2. Keep all shields in place. Keep away from
moving parts.
3. NO RIDERS! Keep all people and pets a
safe distance away. Look behind to both
sides before backing up.
4. DO NOT direct the mower discharge at
people.
5. Avoid slopes. Tractors can be rolled over.
6. Before leaving the operator’s seat: Shut off
the PTO, engage the brake pedal lock, shut
off the engine and remove the ignition key.
Wait for all movement to stop before
servicing or cleaning.
7. Do not fill the fuel tank when the engine is
running or while the engine is hot. Tighten
the fuel cap securely.
BEFORE OPERATING YOUR TRACTOR
1. Before you operate the tractor, study this manual
carefully. It has been prepared to help you operate
and maintain your tractor with utmost efficiency.
2. Familiarize yourself with the operations of all the
instruments and controls.
3. This engine is certified to operate on unleaded
gasoline. For best results, fill the fuel tank with only
clean, fresh, unleaded gasoline with a pump
sticker octane rating of 87 or higher. In countries
using the Research method, it should be 90 octane
minimum.
Unleaded gasoline is recommended because it
leaves less combustion chamber deposits.
Leaded gasoline may be used in areas where
unleaded is not available and exhaust emissions
are not regulated. Be aware however, that the
cylinder head may require more frequent service.
Gasohol (up to 10% ethyl alcohol, 90% unleaded
gasoline by volume) is an approved fuel. Other
gasoline/alcohol blends are not approved.
Methyl Tertiary Butyl Ether (MTBE) and unleaded
gasoline blends (up to a maximum of 15% MTBE
by volume) are approved fuels. Other gasoline/
ether blends are not approved.
4. Check the engine and transmission oil levels.
5. Clean the air cleaner element if necessary.
6. Check the tire inflation pressures.
7. Adjust the seat for operator’s maximum comfort,
visibility and for maintaining complete control of
the tractor.
8. Remove the side panels and clean any
accumulated grass and debris from the engine air
inlet screen. Also clean the dash air intake screen,
grille and side panels to ensure adequate cooling.
9. Refer to the various sections of the Owner’s
Manual for additional information.
STARTING THE ENGINE
WARNING
For personal safety, the operator must be sitting
in the tractor seat when starting the engine.
WARNING
This unit is equipped with a safety inerlock
system designed for the protection of the
operator. Do not operate the tractor if any part
of the interlock system is malfunctioning.
Periodically check the functions of the interlock
system for proper operation as described
below:
• The safety interlock system prevents the en-
gine from cranking or starting unless the
brake pedal is fully depressed and the PTO
clutch engagement switch is in the “OFF” po-
sition.