Filter
Top Products
2-Screw,5/16-18 x 2 In'.
©
2 -Washer, Hvsptlk
B©
2- Nut, 5/16-18 Reghex
Pads
2 - Ignition Keys
{Attached to engine in
plastic bag)
,in carton (not shown full size)
1 - container 5W30 oil
1 - Snow Chute Assembly
THIS SNOW THROWER HAS A TRACK DRIVE SYSTEM EQUIPPED TO GIVE YOU
FREE-WHEELING CAPABILITY
If your snow thrower must be moved without the aid of the engine, it will be easier to pull
the snow thrower backward by the handles rather than pushing. For details on how to use
the free-wheeling capability, see the Track Drive/Frae-Wheel Feature paragraph in the
Operation section of this manual.
On start up, the track drive system may be ti_ghtbut wilt loosen up as the snow thrower is
used. After first use, check the track for tension and adjust if necessary. See the Track
Adjustment paragraph in the Service and Adjustments section of this manual. Check track
adjustment and fasteners regularly.
Z_ CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife tocut carton and plasticties
2 - 1/2 inchwrenches (or adjustable
wrenches)
2 - 9116inchwrenches (or adjustable
wrenches)
2 - 3/4 inchwrenches (or adjustable
wrenches)
1 - Pliers (to spread cotterpin)
1- Screwdriver
1 - Measuring tape or ruler
The figure below shows the snow thrower in
the shipping carton.
Clutch
handle
essemb_j
5
The figure below shows the snow thrower
completely assembled.
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit.
Auger(
drivelever
lever
Chutedeflector
plate
adjustskids