Filter
Top Products
TROIJBLE CAUSE CORRECTION
Difficult starting Defective spark plug Replace defective plug
Water or dirt in fuel system Use carburetor bowl drain to
flush and refill with fresh fuel
Engine runs er- Blocked fuel line or low on fuel Clean fuel line; check fuel sup-
ratlcally ply; add fresh gasoline (gaso-
line/oil mixture if 2-cycle engine)
Engine stalls Unit running on CHOKE Move choke lever to OFF position
Engine runs er- Water or dirt in fuel system Use carburetor bowl drain to
ratlcally; flush and refill with fresh fuel
or
Loss of power
Excessive Loose parts; damaged impeller
vibration
Unit fails to
propel itself
Unit fails to
discharge snow
Unit rides up
Ddve belt loose or damaged
Incorrect adjustment of auger con-
lrol cable
_/om or damaged friction wheel
Auger drive belt loose or damaged
Auger control cable not adjusted
correctly
Shear bolt broken
Discharge chute clogged
Foreign object lodged in auger
Weight transfer disengaged
Stop engine immediately and
disconnect spark plug wire.
Tighten all bolts and make all
necessary repairs, If vibration
continues, have the unit ser-
viced by a Craftsman service
repairman
Replace drive belt
iAdjust traction drive cable
iRepair frict on wheel
Adjust auger drive belt; replace if
damaged
Adjust auger control cable
Replace shear bolt.
e
Stop engine immediately and dis-
connect spark plug wire. Clean
discharge chute and inside of au-
ger housing
Stop engine immediately and dis-
connect spark plug wire. Remove
object from auger.
Engage weight transfer system
by lifting up on upper handle until
bracket bolts snap into place in
upper slots of weight transfer
_edal.
24