Filter
Top Products
17. Disengage power to the auged
impeller when snow thrower is
transported or not in use.
18. Use only attachments and accesso-
ries approved by the manufacturer
of the snow thrower (such as tire
chains, electric start kits, etc).
19. Never operate the snow thrower
without good visibility or light.
Always be sure of your footing, and
keep a firm hold on the handles.
Walk; never run.
MAINTENANCE AND STORAGE
1. Check shear bolts and other bolts
frequently for proper tightness to be
sure the snow thrower =sin safe
working condition.
2. Never store the snow thrower with
fuel in the fuel tank inside a
building where ignition sources are
present such as hot water and
space heaters, clothes dryers, and
the like. Allow the engine to cool
before storing in any enclosure.
3. Always refer to operator's manual
instructions for important details if
the snow thrower is to be stored for
an extended period.
Contents of Parts Bag (actual size)
1 - Owner's Manual (not shown)
2 - Parts Bags (not shown)
* Non-Assembly Parts ere found In
the toolbox located on top of the
bett cover
4. Maintain or replace safety and instruc-
tion labels, as necessary.
5. Run the snow thrower a few minutes
after throwing snow to prevent freeze-
up of the auger/impeller.
A
/_ WARNING: This snow thrower is for
use on sidewalks, driveways and other
ground level surfaces. _.
Caution should be exemi_ed while using on
steep sloping surfaces. DO NOT USE
SNOW THROWER ON SURFACES
ABOVE GROUND LEVEL such as roofs of
residences, garages, porches or other such
structures or buildings.
*2 - Spare Spacers
3 - Carriage Bolts,
5/16-18xl.00 In.
*2 - Spare Shear Pine
5 - 11/32 Flatwashers
3 -Hex Nylon Nuts,
5/16-18
1- Nut, 1/2-13 Hexlam
L
1- Shifter Knob 1 - Starter Motor Cord 10Ft.