Filter
Top Products
Auger Drive
Clutch
Ignition Key
insert to run
pull out to stop
Z_ CAUTION: Read owner's manual
before operating machine. Never direct
discharge toward bystanders. Release the
auger control bar and stop the engine
before unclogging discharge chute or auger
housing and before leaving the machine.
The operation of any snow thrower can re-
sult in foreign objects being thrown into the
eyes, which can result in severe eye dam-
age. Always wear safety glasses or eye
shields while operating the snow thrower.
We recommend standard safety glasses or
a wide vision safety mask for over your
glasses, available at Craftsman Retail
Stores or Service Centers.
TO CONTROL SNOW DISCHARGE
• Turn the crank assembly to set the direc-
tion of the snow throwing.
• Loosen the wing knob on the chute de-
flector and move the deflector to set the
distance. Move the deflector (Up) for
more distance, (Down) for less distance.
Then tighten the wing knob (see figure
below).
Knob
HOW TO USE YOUR SNOW
THROWER
TO STOP YOUR SNOW THROWER
• To stop throwing snow, release the auger
drive lever (see bottom right figure on this
page).
• To stop the engine, push the throttle con-
trol lever to • (Stop) and pull out the
ignition key (see figure below).
NOTE: Do Not turn key.
ElectricStarter
Primer Button
TO MOVE FORWARD
• Push down the auger drive lever (see
figure below). The auger will assist in self
propelling the unit.
• To reduce the forward drive motion, push
down on the handle, lifting the auger
housing.
AugerDriveLever
/
Ignition
Key
Starter
Handle
TO THROW SNOW
• Push down the auger drive lever (see
figure above).
• Release to stop throwing snow.
Throttle
Control Control
9