Filter
Top Products
Parts packed separately in carton (not shown full size)
2 - Ignition Keys
(Attached to engine in plastic bag)
1 - Crank Assembly
1 - Snow Chute Assembly
,4k
CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife (to cut carton and plastic ties)
2- 1/2 inch wrenches (or adjustable
wrenches)
2- 9/16 inch wrenches (or adjustable
wrenches)
2 - 3/4 inch wrenches (or adjustable
wrenches)
1 - Pliers (to spread cotter pin)
1 - Measuring tape or ruler
The figure below shows the snow thrower in
the shipping position.
The figure to the right shows the snow
thrower completely assembled.
Reference to the right or left hand side
of the snow thrower is from the operator's
position behind the unit.
TO REMOVE SNOW THROWER
FROM CARTON
• Locate all parts packed separately (as
shown above) and remove from carton.
NOTE: Place fuel stabilizer in a safe place
until needed for storage.
Augerdrive
lever
Crank
Assembly
Chute
Deflector
Lower I]andle
Clutch
Cable
Upper
Assembly