Filter
Top Products
• Carefully remove cotter pin, clevis pin and
drilled pin from yoke end of crank rod
assembly (see figure below).
• Place universal joint intoend of worm
gear lining up large holes. Insert drilled
pin (ensure opening in pin is in line with
small openings in universal joint) (see
figure below).
• Place yoke end of crank rod around
universal joint, lining up openings. Insert
clevis pin through assembly and secure
with cotter pin. Spread ends ofcotter pin
with a pair of pliers to lock in place (see
figure below).
• Tighten nut on eye bolt, keeping eye in
line with the rod white tightening the in-
side securely.
Cotter Pin
Clevis Pin
Crank Rod
Assembly
Joint Pin
Universal
Worm Bracket Joint
TO ASSEMBLE SNOW CHUTE
• Turn crank assembly counterclockwise
until it stops.
• Locate three 5/16-18x 1.00 inch carriage
bolts, 11/32 flatwashers and 5/16-18 hex
nylon nuts (found in parts bag).
• Position snow chute on snow chute flange
and align the three holes in the snow
chute with holes in the snow chute flange
as shown in next figure. NOTE: You may
need to turn crank assembly in order to
install hardware for chute assembly.
• Install carriage bolts from inside of chute
as shown in next figure, flatwashers and
nuts.
• Tighten carriage bolts securely. Be careful
not to overtighten. See next figure.
• Turn crank assembly clockwise and make
sure all carriage bolts are tight.
Snow
Chute
Flatwasher
Hex Nylon
TO CHECK/ADJUST CLUTCH
CONTROL CABLE
The control cable, see figure below, at-
tached to the auger clutch lever may need
to be adjusted before you use your snow
thrower.
For instructions on checking or adjusting
the control cable, (see "To Adjust the Clutch
Control Cable on page 14).
Auger Clutch_. Off
Lever _,,_
ControlCable_..j
/
,/ CHECKLIST
Before you operate your new snow thrower,
to ensure that you receive the best perfor-
mance and satisfaction from this quality
product, please review the following
checklist:
,/" All assembly instructions have been
completed.
,/ The discharge chute rotates freely.
,/ No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the following
important items:
/#" Engine oil is at proper level.
/,/ Make sure gas tank isfilled properly
with clean, fresh, unleaded gasoline.
•// Become familiar with all controls-their
location and function. Operate controls
before starting engine.