Filter
Top Products
TROUBLE CAUSE CORRECTION
)ifficult starting Defective spark plug Replace spark plug
Water or dirt in fuel system Use carburetor bowl drain to flush
and refillwith fresh fuel.
Engine runs Blocked fuel line or low on fuel Clean fuel line; check fuel supply;
erratically tank or stale gasoline add fresh fuel (gasoline/oil mix
tura if2-cycle engine).
Engine stalls Unit running on CHOKE Move choke lever to OFF position.
Engine runs Water or dirt in fuet system Use carburetor bowl, drain to flush
erratically; & refillwith fresh fuel.
or
Loss of power
Loose parts; damaged impeller Stop engine immediately and dis
Excessive connect spark plug wire. Tighten
vibration all bolts and make all necessary
repairs. Ifvibration continues, have
the unitserviced by a Craftsman
service repairman.
Side plates touching ground
Units fails to
propel itself
Unit fails to
discharge
snow
Auger drive belt loose or damaged
Auger control cable not adjusted
correctly
Shear bolt broken
Discharge chute clogged
Foreign object lodged in auger
Adjust side plates. See to Adjust
Side Plates in the Adjustment sec-
tion.
Check auger drive belt, replace if
necessary.
Adjust auger control cable.
i Replace with shear pin found in
tool box located on belt cover.
Stop engine immediately and dis
connect spark plug wire. Clean dis
charge chute and inside of auger
housing.
Stop engine immediately and dis
connect spark plug wire. Remove
object from auger.
18