Filter
Top Products
CotterPin
Clevis Pin
Crank Rod
Figure 6
Chutein Operating __
Position
Figure 8
ASSEMBLE SNOW CHUTE
1. Remove back carriage bolt. See
Figure 7.
2. Tilt chute back into operating posi-
tion. See Figure 8.
3. Replace carriage bolt from inside of
chute.
4. Replace fiat washer and nylon lock-
nut on outside of flange.
5. Tighten carriage bolt securely.
NOTE: Check all carriage bolts in
flange for tightness. DO NOT over-
tighten.
Shipping Position
\
Remow
Carriage
Figure 7
F-OOIO60J
NOTE: If the cables have become dis-
connected, reinstall springs as shown in
Figure 9.
AugerDrive I
TractionDrive Spring(Short ,_
Spring(Long) _
I ' ' -- Figure9
CONNECT REMOTE CHUTE
1. Push remote chute control lever into
"Chute Deflector Up" position.
2. Feed "Z" fitting through hole in re-
mote chute bracket. See.
3. Snap remote chute control cable
into remote chute bracket. See.
4. Connect "Z" fitting into remote chute
control bracket. See.
5. Push remote chute control lever into
"Chute Deflector Down" position.
6. Cut tie strap on chute deflector. See
Figure.
SPEED SELECT LEVER
1. Cut plastic tie securing speed select
lever assembly to the shifter brack-
et. See Figure 10.
2. Remove Iocknut, washer, spring,
and the bolt. See Figure 12.