Filter
Top Products
_lh ARNING: Always wearsafety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knife to cut carton
t - 1/2 inch wrenches
(or adjustable wrenches)
1 - 9/16 inch wrenches
(or adjustable wrenches)
1 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
t - Measuring tape or ruler
Figure 1 shows the snow thrower in the
shipping position.
Figure 1
Figure 2 shows the snow thrower com-
pletely assembled,
References to the right or left hand side
of the snow thrower are from the view-
point of the operator's position behind
the unit.
Auger
Shifter
Lever
Traction
Lever
Cable
Chute
Chute
Deflector
Figure 2
TO REMOVE SNOW THROWER
FROM CARTON
t. Locate all parts packed separately
and remove from the carton.
NOTE: Place fuel stabilizer in a safe
place until needed for storage.
2. Remove top pallet from carton.
3. Cut and discard the plastic ties se-
curing the chute rod to the upper
pallet and place aside. Discard pal-
let.
4, Cut down all four corners of the car-
ton and lay the panels flat.
5. Cutthe bands holding the snow
thrower to the lower pallet.
6. Remove snow thrower from lower
pallet.
7. Remove the packing material from
the handle assembly and all protec-
tive material from unit and discard,
8. Cut ties securing the clutch control
cables to the lower handle.
F_301060J 7