Filter
Top Products
3. Positionspeedselectorlever as-
sembly as shown in Figure 11.
4. Reinstall bolt, spring, washer and
Iocknut See Figure 12.
5. Tighten Iocknut until 1/8 to 3/16 inch
of the bolt threads protrude pas the
Iocknut.
6. Thread the 3/8-16" hex jam nut
onto the lever until the nut reaches
the end of the thread. See
Figure 12.
7. Thread the plastic knob as far as
possible and ensure that the knob
points forward.
8. Tighten the 3/8-16" hexjam nut
against the knob securely.
9. Move shifter through all speeds to
ensure proper tension of the spring.
If shifter lever sticks in any of the
notches, loosen Iocknut 1/2 turn at a
time until shifter lever moves more
freely.
10. If adjustment of speed of snow
blower is needed, refer to "Friction
Wheel Adjustment" in the ADJUST-
MENT/REPAIR section.
Shifter
Bracket
Plastic
Tie
Control
Panel
Figure 10
Figure 11
F-OOIO60J 10