Filter
Top Products
• :,k!
.r . _"
r ,
OPERATION
HOWTO USE YOUR CHAIN SAW
STOPPING YOUR ENGINE
' Move on/stopswitch to the "Stop"position.
, If engine does not stop, pullb_uechokeknobout fully.
CHAIN OILER (Fig. 7)
• The chain oiler provides continuouslubricationto the
chainand guide bar.Be sureto figthe bar oil tank when
you fillthe fuel tank (Capacity= 6.8 fl,oz.).
• Yourchain saw will consume approximatelyone tank of
CHOKE/FAST IDLE SPEED
• The choke and fast idle speed are set by pulling the
chokelever outfully for coldor refueled engine starts.
• Squeezing the throttletriggerwill release the chokeand
fast idle settings.If the throttletrigger is squeezed acci-
dentally during starling, it will be necessary to reset
throttleadvance by pullingchoke lever out fully.
• The choke providesadditionalfuel when starting a cold
engine.
• The chokeis actuated bypullingthe blue choke knob,
• The chokehastwo positions: off and full.
bar oilfor each tank of fuel used.
• Your chainoiler isautomaticand requiresnoadjustment.
Handle
Bar
Oil Fill Fuel MixCap
Figure7
THRO'n'LE CONTROL GROUP (Fig. 8)
THROTTLE LOCKOUT
• The throttle lockout prevents unintentionalactuation of
the throttletrigger.
° You mustdepress the throttlelockoutwith the palm of
your handbefore actuating the throttletrigger.
THROTTLE TRIGGER
• The throttle trigger allows for vadablecontrolof engine
speed.
• The throttle trigger is actuated by the indexfingeron your
dght hand. (After the throttlelockoutisdepressed).
Throttle
Lockout
Throttle
Figure8
Figure9
".:::?