Filter
Top Products
NEUTON EM 4.1 Cordless Electric Mower Safety & Operating Instructions 31
3. Place the 36 mm wrench over the steel hex
adapter holding the blade (the large metal piece
that holds the blade in position).
4. Place the ¾ inch socket wrench over the blade
nut.
5. While holding the steel hex adapter in place,
loosen the blade nut turning counterclockwise
Be careful; hold the steel hex adapter in place
so the blade does not spin and strike your hand
(Figure 31).
6. Remove the blade nut, steel hex adapter, blade,
plastic spacer, and steel blade adapter, in that
order (Figure 32).
7. To replace a sharpened blade or to install a new
blade, reverse steps 1 to 6. Be sure to replace all
parts exactly as they were removed. Make sure the
blade is properly seated.
8. Place the 36 mm wrench over the steel hex
adapter., then place the ¾ inch socket wrench over
the blade nut.
9. While holding the steel hex adapter in place,
tighten the blade nut turning clockwise. Make sure
the blade is frimly attached to the mower.
10. Turn your mower upright.
Sharpening the Blade
When the blade is dull, the cut ends of the grass will
be ragged and may turn brown soon after mowing. A
dull blade also causes the battery to discharge more
quickly. When this occurs, sharpen the blade (as long
as the blade is otherwise in good condition).
For best results, remove the blade from the mower to
sharpen it.
Tools & supplies needed:
■ Fine-toothed file or sharpening stone
■ Gloves
■ Safety glasses
Figure 31. Removing the blade
Figure 32. The order of the parts holding
the blade