Filter
Top Products
NEUTON EM 4.1 Cordless Electric Mower Safety & Operating Instructions 19
Stopping the Motor and Blade
Simply releasing the control levers stops the motor and blade.
Important: The blade will continue to rotate for a few seconds after the motor is shut off.
When Finished Mowing
Remove the safety key when the mower is unattended and the motor is shut off.
Remember to recharge the battery after each use, no mater how short a time it was used. See
“Charging the Battery” in Chapter 5 for details.
Adjusting the Cutting Height
Using the cutting height lever (Figur e 19), adjust the cutting
height to cut 1 to 2 inches of grass at a time.
1. Remove the safety key.
2. Make sure all four wheels are level.
3. Pull the lever (toward the wheel) out of its position
notch. (The cutting height lever is spring-loaded.)
To easily adjust the cutting height, hold the handlebars with
your right hand to keep the mower steady and adjust the
lever with your left hand.
4. Move the lever to any one of the six cutting height
settings.
Each position moves the mower to cut a different cutting height. Pulling the cutting height lever up
towards position 1 cuts more grass (which leaves your grass shorter); pushing it down towards posi-
tion 6 cuts less grass (leaving your grass higher). The following table lists the final cut grass heights.
Lever Position Cut Height
1 1.6″ (40 mm)
2 2.0″ (50 mm)
3 2.4″ (60 mm)
4 2.8″ (70 mm)
5 3.2″ (80 mm)
6 3.6″ (90 mm)
WARNING! The safety key, with its built-in circuit breaker, should never
be inserted during assembly, adjustments, cleaning, blade replacement,
or when the mower is not in use. Removing the safety key will prevent
accidental starting, and help avoid serious personal injury.
Figure 19. Cutting height lever set
to leave your grass 1.6 inches high