Filter
Top Products
NEUTON EM 4.1 Cordless Electric Mower Safety & Operating Instructions 29
Removing the Rear Bagger
1 Unlock the orange tab on the rear bagger handle.
2. Raise the discharge guard, grab the rear bagger by its handle and remove it by lifting it up while
pulling out.
3. Release the discharge guard.
Installing the Mulching Kit
To mulch your grass, install both the mulching plug and
blade.
1. If necessary, remove the rear bagger or the rear
discharge plate from the mower.
2. Install the mulching plug (Figure 29). Be sure to push the
plug all the way in until the notch in its bottom is
engaged.
There’s a slight knack to installing the plug: push with a
slightly arcing motion. Align the plug in the mower, start to
push the top of the plug first then put pressure towards the
bottom and slide in the plug.
3. Remove the cutting blade and install the mulching blade.
For detailed instructions, please refer to “Removing and Attaching the Blade” in Chapter 7.
Please refer to Figur e 30 for a comparison of the two
blades. Notice that the cutting blade has a longer
stabilizer in the blade’s center, and one edge of both
ends is turned up. The mulching blade, on the other
hand, has a much smaller stabilizer and does not have
any edges turned up.
Figure 30. Comparing the cutting blade
(top) with the mulching blade (bottom)
Figure 29. Installing the mulching
plug