Filter
Top Products
10 NEUTON EM 4.1 Cordless Electric Mower Safety & Operating Instructions
Assembling Your NEUTON Mower
To allow you to quickly begin using your NEUTON mower, it is shipped to you partially assembled.
The assembly process is easy and does not require any special tools, knowledge, or strength.
Assembling your NEUTON takes just a few steps:
Step 1: Read these “Safety and Operating Instructions” before proceeding.
Step 2: Attach the lower handlebar sections.
Step 3: Attach the upper handlebar assembly.
Step 4: Cut and remove the strapping holding the battery in place.
Step 5: Attach the cable to the handlebar assembly.
Step 6: Charge the battery before your first use.
Step 7: Attach the rear discharge plate.
Each of these steps is described in detail below. (See page 14 for the fully assembled mower.)
Step 1: Read the Safety and Operating Instructions
Before Proceeding
The NEUTON Mower is a motorized cutting machine that uses a sharp blade. For your safety, and
for the best results, it is important to read the information in “Chapter 2: Important Safety
Considerations” before you assemble or use the mower.
To familiarize yourself with the assembly, features, and operation of your mower, please read the
remainder of this manual before proceeding.
Step 2: Attach the Lower Handlebar Sections
To keep the mower from moving while you assemble it, put a foot behind one of the wheels.
Use the green quick-connect knobs to attach the lower handlebar sections to the mower. The
installation process is the same for each handlebar.
Note: Set the cutting height to the highest adjustment
position when attaching the lower handlebar sections
(position 6 in Figure 2). This makes it easier to reach the slots
on the mower frame.
1. Position the lower handlebar, with the indentation facing
out, against the frame of the mower. Slide it down into
the slot on the frame until the holes line up (Figure 2).
Be sure to slide the lower handlebar with the cable guide
tab (see Figur e 3) on the right side (from the operator’s
point of view) of the mower.
2. Insert a green quick-connect knob through the lined-up
holes in the handle and mower frame to attach each side
of the lower handlebar to the mower.
3. Hand tighten until firmly snug.
Important: Be sure to tighten the green quick-connect knobs by hand. Do not use a tool to
tighten; you could easily over tighten them and damage the parts.
Figure 2. Attaching the lower left
handlebar