Filter
Top Products
Operation 4-7
Compaq Confidential – Need to Know Required
Writer: Debbie McRill Project: Compaq DAT AutoLoader Reference Guide Comments:
Part Number: 326817-003 File Name: e-ch4 Operation.doc Last Saved On: 2/15/00 10:52 AM
Figure 4-9. Slide stopper
2. To remove cassettes in positions 1 through 5 use the access slots on the
bottom of the magazine to slide the cassettes out the front of the
magazine.
3. Turn the magazine opening slots up. Gently tap the unit until the
cassettes in positions 6 and 7 drop to the bottom slots.
4. Repeat steps 1 and 2.
5. Press the magazine stopper down to pull the cassette from position 8.
Ejecting the Magazine
To eject a cassette magazine from the DAT AutoLoader, press the Eject
button or issue an UNLOAD command from the host. The following sequence
of events occurs:
1. The tape is rewound to BOP (Beginning of Partition).
2. If the tape is write-enabled, the copy of the tape log held in RAM is
written back to the tape.
3. The tape is then rewound to BOM (Beginning of Media) and
unthreaded.
4. The AutoLoader replaces the cassettes in the magazine in the correct
order.
5. The magazine is ejected.