Filter
Top Products
Installation
2-9
Compaq Confidential – Need to Know Required
Writer: Debbie McRill Project: Compaq DAT AutoLoader Reference Guide Comments:
Part Number: 326817-003 File Name: c-ch2 Installation.doc Last Saved On: 1/25/00 10:01 AM
Connecting the Tabletop AutoLoader
For the tabletop DAT AutoLoader, follow the procedures below to connect to
a Compaq computer:
1. Set the SCSI ID using the switch at the rear of the DAT AutoLoader
(See Figure 2-6). The SCSI ID switch can be adjusted by using a pencil
or similar object to click the “+” and “-” buttons. The SCSI ID default
is 6.
1
Figure 2-6. External AutoLoader SCSI and options switches
2. Set the configuration switches located on the bottom
1
of the
AutoLoader, if required. See the previous section, “Switch Settings,” for
switch descriptions and settings.
3. Connect the SCSI signal cable from the computer to one of the two
SCSI connectors at the rear of the tabletop DAT AutoLoader.
4. Connect the external terminator (provided with the tabletop DAT
AutoLoader kit) to the unused SCSI connector.