Filter
Top Products
Installing Software Drivers
3-5
Compaq Confidential – Need to Know Required
Writer: Debbie McRill Project: Compaq DAT AutoLoader Reference Guide Comments:
Part Number: 326817-021 File Name: d-ch3 Installing Software Drivers.doc Last Saved On: 1/25/00 10:06 AM
Drivers for the SCSI controllers and tape drive hardware are located on the
Support Software Diskettes and on the Compaq SmartStart and Support
Software CD. The Support Software ships with each computer or can be
downloaded from the Compaq website. The software tape device driver is
located either with your tape backup software or with the operating system.
Refer to your backup application installation guide for more information
regarding additional software that might be needed
.
Table 3-3
SCO OpenServer
Controller Software Driver Information
■
32-Bit Fast SCSI-2 Controllers
■
32-Bit Fast-Wide SCSI-2 Controllers
■
Wide-Ultra SCSI Controllers
■
LVD Wide SCSI Controllers
Refer to the appropriate
README
on the
Compaq Support Software CD.
The name of the driver is
CHA.
In addition, the appropriate version of the Compaq Extended Feature
Supplement (EFS) for SCO OpenServer is required:
■
For SCO OpenServer 5, use Compaq EFS version 5.16 or later.
EFS for SCO OpenServer is available on both the Compaq SmartStart and
Support Software CD and is installed and configured automatically during a
SmartStart installation.
Configuring the SCSI ID for SCO OpenServer
In the pre-configured kernel used to install SCO OpenServer, the following
SCSI IDs are automatically set:
■
Disk = 0
■
Tape = 2
■
CD-ROM = 5
To determine the SCSI ID of the new tape drive (if not known):
1.
Run System Configuration and look under “Review or Modify
Hardware Settings,” then “View and Edit Details.” The values reported
for controller number, target ID, LUN, and bus number are used during
mkdev tape.
2.
Boot the computer to single user mode and run the
mkdev tape
command.