Filter
Top Products
Page 7SKU 91995 For technical questions, please call 1-800-444-3353.
The Cross Pin (28) should always be in the “locked down” position when
the Saw is not being used and when the Saw is being transported. The
Cross Pin should be activated in the “locked up” position when changing
Saw Blades. NEVER use the Cross Pin in any cutting operation. The Cross
Pin allows the operator to lock the Saw Blade in position, preventing the Saw
Blade from being raised or lowered.
Allow the Saw Blade to spin up to full speed before feeding it into the
workpiece. Do not force the Saw Blade into the workpiece when cutting. Apply
moderate pressure, allowing the Saw Blade to cut without being forced. When
turning off the Saw, allow the Saw Blade to spin down and stop on its own. Do
not press against the Saw Blade to stop it.
Turn off the Saw and allow the Saw Blade to stop on its own if the Saw
Blade is to be backed out of an uncompleted cut.
Industrial applications must follow OSHA requirements.
Proper Miter Saw location: Make sure the Miter Saw is located on a at, level,
sturdy surface capable of supporting the weight of the Miter Saw, workpieces,
and all other tools and accessories.
Do not abuse the Power Cord. Do not use the Power Cord to pull the Power
Plug from an electrical outlet. Keep the Power Cord away from heat, oil, sharp
edges, and moving parts. Route the Power Cord safely. Do not route the Power
Cord where it can be walked on or tripped over. Replace a damaged Power Cord
immediately.
Keep all safety guards in place, in proper adjustment, and in proper
alignment.
Never attempt to remove material stuck in the moving parts of the Miter
Saw while the machine is plugged in and running.
Whenever possible, use clamps or other safe, practical ways to hold and
support the workpiece. Do not attempt to cut material that does not have a at
surface, unless a suitable support is used.
Always keep hands and ngers away from the spinning Saw Blade.
Use eye, hearing, and breathing protection. Always wear ANSI-approved
safety impact eye goggles, hearing protectors, and dust masks or respirator
when working with the Miter Saw.
Do not use this product if under the inuence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgement or reexes are
impaired while taking drugs. If there is any doubt, do not attempt to use this
product.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.
26.