Filter
Top Products
Page 19SKU 91995 For technical questions, please call 1-800-444-3353.
o
2. The bevel angle (or Saw Blade tilt capacity) may be adjusted from 0 - 45 to the
left. To do so, loosen the Handle (30) located at the rear of the Miter Saw.
(See Figure P.)
3. Tilt the Back Rack (25) until the desired bevel angle of cut is achieved as indi-
cated on the Gauge (24). Then, re-tighten the Handle (30) to lock the Back Rack
in place. (See Figure P.)
Basic Operation:
1. Make sure the Power Cord (102) of the Miter Saw is unplugged from its
electrical outlet. Then, if necessary, make adjustments to the workpiece Holder
(9), cutting depth, miter angle, and bevel angle.
2. Raise the Saw Blade (56) up to allow positioning of the workpiece.
3. Check to make sure the Power Switch (98) is operating properly.
4. Place the workpiece on the Table (18) and against the Guide Fence (37).
5. Use the Clamp Assembly (36) to hold the workpiece in place.
FIGURE P
HANDLE
(30)
GAUGE
(24)
BACK RACK
(25)