Filter
Top Products
Page 21SKU 91995 For technical questions, please call 1-800-444-3353.
3. Daily: With a soft brush, cloth, or vacuum, remove all dust and debris from
the Miter Saw. Then, use a premium quality, lightweight machine oil to lubricate
all moving parts except the Saw Blade (56).
4. To replace the Motor Carbon Brushes: It may become necessary at some-
time to replace the two Carbon Brushes (73) when the Motor performance de-
creases, or stops working completely. The Carbon Brushes are located on
each side of the Motor Housing (75). To do so, remove the two Brush Covers
(72). Then, remove the two Carbon Brushes from the Brush Holders (74).
If the Carbon Brushes are worn down more than 1/2, replace both Carbon
Brushes. If, however, the Carbon Brushes are just dirty they may be cleaned by
rubbing them with a pencil eraser. When installing the Carbon Brushes, make
sure the carbon portion of the Carbon Brushes contact the Motor Armature, and
that the springs face away from the Motor. Also, make sure the springs operate
freely. After cleaning or replacement, replace the Brush Holders.
NOTE: New Carbon Brushes tend to arc or spark when rst used until they
wear and conform to the Motor’s Armature. (See Figure Q.)
5. NOTE: With the exceptions of Steps #1, #2, #3, and #4 all other
maintenance and servicing should be performed only by a qualied service
technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED
AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
FIGURE Q
CARBON BRUSH
(73)
CARBON BRUSH (73)
(NOT SHOWN)