Filter
Top Products
Page 20SKU 91995 For technical questions, please call 1-800-444-3353.
6. Plug the Power Cord (102) into the nearest 120 volt, grounded, electrical
outlet.
7. Squeeze the Power Switch (98) to turn on the Miter Saw.
8. When the Saw Blade (56) is turning at full speed, slowly bring down the Motor
Housing (75) to complete the cut. NOTE: Feed the Saw Blade into the
workpiece gradually. Do not force the machine to remove material faster than it
was designed to cut.
9. When cutting a large workpiece, make sure its entire length is properly
supported. If necessary, use a roller stand (not included) with a larger workpiece.
10. Never attempt to remove material stuck in the moving parts of the Miter Saw
while it is plugged in and running.
11. Turn off the Miter Saw if the workpiece is to be backed out of an uncompleted
cut.
12. When the cut is complete, release the Power Switch (98) to turn off the Miter
Saw.
13. Wait until the Saw Blade (56) comes to a complete stop. Raise the Motor
Housing (75). Then, unplug the Power Cord (102) from its electrical outlet.
14. Loosen the Clamp Assembly (36), and remove the workpiece and scrap material
from the Table (18).
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Always make sure the Power Switch (98) is in its “OFF”
position, and unplug the Power Cord (102) from its 120 volt electrical outlet
before performing any inspection, adjustments, maintenance, or cleaning.
Make sure the power tool is cool to the touch before inspection, maintenance,
and cleaning begin. Always protect your hands by wearing work gloves.
2. Before each use, inspect the general condition of the Miter Saw. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, loose, cracked, or bent Saw Blade (56), and any other
condition that may affect its safe operation. If abnormal noise or vibration occurs,
have the problem corrected before further use.
Do not use damaged equipment. Never work with a dull saw blade.