Filter
Top Products
6
2
1
3
4
Place the center le
g
brace between the tri
p
od le
g
s
and ti
g
hten the tension knob so that the brace
p
ushes out a
g
ainst the le
g
s. Loosen the extension
clamp at the end of each tripod le
g
and slide down
the inner
p
ortion of the le
g
to the desired hei
g
ht.
Ti
g
hten the extension clam
p
to hold the le
g
s in
place.
Tension
Knob
Leg
Extension
Clam
p
Center Le
g
Brace
With the tri
p
od set u
p
outside, lift the telesco
p
e b
y
the
carr
y
in
g
handle on each fork arm and carefull
y
lower i
t
onto the tri
p
od head. Make sure that the hole in the
bottom of the drive base
g
oes over the
p
ositionin
g
p
in in
the center of the tri
p
od head. Rotate the base until the
holes line-u
p
with the mountin
g
holes on the tri
p
od.
Thread the three mountin
g
bolts from underneath the
tripod head into the bottom of the telescope base.
Attach the included accessories (eyepiece, diagonal and
finderscope) and remove the front lens cover. Align the
finderscope on a distant object. (For instructions on
aligning the finderscope, see the Assembly section of the
manual).
Eyepiece
Star
Diagonal
Finderscope
Tripod Head
Drive Base
Mountin
g
Bol
t
Carrying
Handle
Carrying
Handle
Positioning
Pin
Altitude
Clutch
Lock Lever
Loosen the Altitude Clutch Lock Lever and rotate
the telescope tube upwards until it is level with the
ground. Tighten the Lock Lever.