®
3
8
WALLCONTROLANDHARDWARE (not to scale)
SwitchMounting
Screws(2)
Wall Plate
Screws
(2) White
(2) Almond
White Wall
Plate(1)
W-85
Wall Control
SwitchBezels
(1) White
(1) Almond
Almond Wall
Plate(1)
(4)WireCap
BeforeinstallingtheW-85wallcontrolyouwillneedto
check and see if you will need to change the bezel on
thefrontofthewallcontrolfromWHITEtoALMOND.
If you are going to use white, skip these steps and go
towallcontrolinstallationstartingonpage1.The
bezel can be changed at any time before or after
installation. The wall control does not need to be
uninstalled to replace the bezel.
W-85 Wall Control Bezel Replacement installation
as follows
Step 17a.Locatethefour(4)tabsholdingthebezelto
the front of the switch, then press in on each tab one
at a time, removing the bezel as shown in Figure #1.
Step 17b.Locatetherubberkeypadattachedto
thefour(4)locatingpinsasshowninFigure#2and
removerubberkeypadfromtheWHITEbezel,also
as shown in Figure #2.
WARNING!
To avoid possible electrical shock, make cer-
tain that electricity is turned off at the circuit
breaker or fuse box before attempting any in-
stallation or repair procedure
CAUTION! NOT turningthe powerOFFat the
circuit breaker or fuse box may cause damage to
the electronics within the wall control and or the PC
board on the fan.
Figure #2
WHITE
BEZEL
RUBBERKEY
PAD
LOCATING
PINS(4)
LOCATING
PINS
HOLES(4)
W-85 CONTROL INSTALLATION
Figure #1
BEZEL
BEZEL
TABS