Casablanca Fan Company 3873Z Outdoor Ceiling Fan User Manual


  Open as PDF
of 17
 
®
3
16
Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance.
TROUBLESHOOTING TIPS
ThisdevicecomplieswithRSS-210ofIndustryCanada.Operationissubjecttothefollowingtwoconditions:(1)thisdevice
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
1.Thisdevicecomplieswithpart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:(1)thisdevice
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
2.ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttoPart15of
theFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordancewiththeinstructions,maycauseharmfulinterferencetoradiocommunications.Howeverthereisnoguarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interferencebyoneormoreofthefollowingmeasures:Reorientorrelocatethereceivingantenna,Increasetheseparation
between the equipment and receiver, Connect the equipment into an outlet on a circuit different from that to which the receiver
isconnected.Consultthedealeroranexperiencedradio/TVtechnicianforhelp.Note:Anychangesormodicationstothe
transmitter or receiver not expressly approved by Casablanca Fan Company may void one’s authority to operate this remote
control.
PROBLEM POSSIBLEREMEDIES
Fanwillnotstart • Checkthemaincircuitfuses,circuitbreakers,andwallswitchposition.
Checkallwireconnections.Makesurethepoweristurnedoffduringthis
inspection.
• Pinconnectorsarenotmakinggoodcontact.Checkallconnections.
• Thefanreceiverisdefective.Replacethefanreceiver.
• Resetthefrequencysetting:Turnthepoweroffatthecircuitbreaker
forthefanthatisnotfunctioningonly.Within20secondsfromrestoring
powertotheceilingfanandtheW-85WallControlpressandholdboth
the“Fan”and“REVERSE”buttonsasshowninFigure#2for3seconds,
you will hear one tone from the Piezo Buzzer indicating the command
hasbeenaccepted.TheFanwillcomeonat“low”speedinthereverse
direction.
Fanwobblesorshakesexcessively • Besurethecanopypinissetproperlyintotheslotontheball.
• Checkthatthebladeholdershavenotbeenbentduringinstallationand
the blades are balanced.
• Thehangerbracketand/ortheceilingoutletareattachedtooloosely.
Makesurethehangerbracketisattachedtightlytotheceilingoutletbox
andthedownrodassemblyissecuredrmly.
• Thedownrodisattachedtothedownrodbasetooloosely.Makesureall
the screws are securely tightened.
Fanisnoisyduringoperation • Whenchangingfanspeeds,youmayhearseveralaudibleclicks.Thisis
normal operation.
• Checkandtightenthelightxtureretainingscrews,glassshadescrews,
and/or lightbulb(s).
• Tightenthecanopyscrewsandmountingplateassembly.Makesure
the wire nuts inside the canopy and switch housing are not touching the
metal parts and that they have not fallen off the wire splices. Tighten as
necessary.
• Tightenthebladeholderstotheywheel(orDirectDrivemotor)andthe
blades to the bladeholder screws.
• Makesureallthescrewsinthemotorhousingaresnugbutnotoverly
tight.
Fandoesnotrunonlowspeed • Iffanisnew,itmayneedtobe“brokenin.”Runathighspeedforseveral
days.
 previous