Casablanca Fan Company 3873Z Outdoor Ceiling Fan User Manual


  Open as PDF
of 17
 
®
3
13
CHANGING FREQUENCY SETTING
NOTE: All fans leave the factory set to
“1111”
You will only have to change the dip switch settings in the remote if you are using
more than one fan in the same area and want to control them separately.
Step1.TurnpowerOFFatthecircuitbreakerorfuseboxandatthetoggleswitch,
for the fan you want to change.
DIP
SWITCHES
DIP SWITCHES
SET TO ‘1111’
(Factory Setting)
DIP SWITCHES
SET TO ‘1001’
AUTOMATIC DEMONSTRATION PROGRAM
• Lightsslowlyincreasetofullintensity.
• Fanacceleratestospeedthreewithaudiotones.
• Lightdimstohalfintensity.
• Fanacceleratestofullspeedwithaudiotones.
• Fanreversesatfullspeedwithaudiotones.
• Fanoperatesatfullspeed.
• Fanturnsoffwithaudiotones(bladescoastforashorttime).
• Lightsturnoff.
The complete cycle lasts slightly over one minute. It will
continue to repeat until the is turned off for more
thanveseconds,cancellingtheprogram.
Programmed into every Inteli-Touch
®
3Seriesfanisan
Automatic Demonstration Program. It can be used to fully
demonstrate and test the operation of the fan.
To enter the demonstration program:
1. Turn offforatleast5seconds.Thiswillclearthe
fan memory ready for programming.
2. Turn on.
3. Immediatelyoperatethebuttonsinthefollowingsequence:
A multi-tone signal will verify the start of the test program
whichproceedsasfollows:
+
+
+ +
NOTE:DONOTsetdipswitchsettingintheremote
to‘0000’,thismaycausefrequencyinterferencefrom
other Casablanca Products.
Step2.Removethescrewsandswitchplatefromtheexistingswitchbox.
Step3.Removethescrewsholdingtheswitchintheswitchbox.
Step4.PulltheexistingW-85switchfromtheswitchboxtoexposethedipswitches
located on the side of the control as shown in Figure #1.
Step5.Changethedipswitchsettings,assuringthattheyaredifferentfromthe
previously installed Inteli-Touch
®
3fan.
Step6.MounttheW-85WallControlunitbackintothewallelectricalbox.
Step7.Atthecircuitbreakerorfuseboxandatthetoggleswitch,turnthepoweroff
for the fan whose frequency you are changing.
Step8.Within20secondsofrestoringpowertotheceilingfanandtheW-85Wall
Controlpressandholdboththe“FAN”and“REVERSE”buttonsasshowninFigure
#2for3seconds,youwillhearonetonefromthePiezoBuzzerindicatingthecom-
mand has been accepted.
 previous next