Casablanca Fan Company 3873Z Outdoor Ceiling Fan User Manual


  Open as PDF
of 17
 
®
3
12
OPERATION POWER
The button is normally left in the on position. Always turn the power off during
cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter ad-
ditional programs.
The
button must be left on to retain a previously set fan speed or light level.
OPERATION SPEED CONTROL
FANCONTROL
ON-OFF:
A momentary
press of the FAN
button
CHANGESPEED:
Press and hold
FAN button longer
than one second
There are six individual speed settings for the fan; each speed is indicated by an
audible tone of increasing pitch.
Toselectthedesiredfanspeed:
1. With fan off, press and hold the button labeled . The fan blades will start rotating
at the slowest speed, and will increase in steps.
2.Releasethebuttonwhenthedesiredspeedisreached.
The fan speed is now in memory and will automatically come on at the same
speed each time the
button is used. To maintain this level of speed, turn
the fan on by pressing
less than one second. To lower speed, turn fan
off, then on by pressing and holding the
button until the desired speed
is reached. When the fan is on, you may increase the speed by pressing and
holding the
button until the desired speed is reached, then release it.
OPERATION REVERSING AIRFLOW
Thedirectionofairowcanbechangedfromdownwardto
upward or from upward to downward.
Toreversetheairow:
1.Makesurethe is on and blades are Turn-
ing.
2. Press the button.
Note: A four-toned signal
indicates the command was
accepted by the fan. A few
seconds later the fan will slow
to a stop and then reverse
direction.
LIGHTCONTROL
ON-OFF:
A momentary press of
the LIGHT button
CHANGEBRIGHT-
NESS:
PRESSANDHOLD
LIGHTBUTTON
LONGERTHANONE
SECOND
To turn the lights off and on, press and release the button for less than one second.
1) First press/release of the button- The light will turn ON.
2)Secondpress/releaseofthe button- The light will turn OFF.
Tovarythelightbrightnessateachtouchlevel:
To vary the light brightness:
1. With lights off, press and hold the button. After one second the lights will
come on at their lowest level and gradually become brighter.
2.Releasethebuttonwhenthedesiredbrightnesslevelisreached.
OPERATION LIGHTS
NOTE: Light Operation - the light varies from “bright”to “dim” over
approximately 8 seconds. This sequence will reverse the light when it reaches
thebrightestordimmestlevelifyoucontinuetoholdtheLIGHTbutton.
Releasethebuttonwhenthedesiredlevelisreached.
The brightness level is now in the fan memory and will automatically come on at
the same brightness the next time the button is used.
 previous next