Filter
Top Products
51
Green - NOTE: Only used with flat blade kit
HM2009
HM2007
Note the correct mounting of the cutting disc
which is to be 3 mm offset.
Always use LOCKTITE 242 on the bolts
of the cutting discs.
Models HM2007, HM2008, HM2009
(Outside Crop Divider)
Models HM2008, HM2009
(Inside Crop Divider)
(59 ft./lbs.)
Cutting Disc Offset
14. Remove bolts from hubs to allow installation of
blade cutting discs. (Figure 10) Refer to illustration on
next page for correct positioning of blade cutting discs.
Pay particular attention to blade rotation and arrange
discs at 90° to each other. NOTE: The end discs
(outer end only on 7’ model) use longer bolts to also
hold the cones in place and the nut guards on the
cone discs are “cut out” for clearance. A snap-in plas-
tic cap is provided for each cone.
Figure 10