Filter
Top Products
Optional hillside kit
The spring lock keeps the machine in position in proportion to the tractor. If the machine meets a
firm obstacle, the lock is released and the machine swings to the rear. Refer to the Hillside Kit
Instructions for more information.
The spring lock must be adjusted. Screw (A) is eccentric. Tighten the bolt to minimum 225 mm (8-7/8”)
Refer to Hillside Kit Instructions..
Optional high skid
The skids of the machine are fixed and cannot be height-adjusted. If the machine operates in
fields with many stones, molehills, etc., high skids (B) and (C) are recommended. The cutting
height is then increased to about 60 mm (2 -3/8”). Also refer to NOTE on page 25 for height adjust-
ment.
Fitting: Set of skids, 2 pcs., are to be placed in the right hand and left hand side of the machine.
They must be fitted below the fixed skids as shown in photos 3 and 4.
③ - ④
① - ②
37