Filter
Top Products
10. Remove pin from top of three point lift frame
to allow instrallation of stabilizer cylinder assembly.
(Figure 8)
Model HM2009 Models HM2007 & HM2008
Before mounting stabilizer, pull out the
piston/rod of the hydraulic cylinder.
Attach Hydraulic Hose With Clamp
Figure 8 Cylinder Mounting Hole Locations
11. Remove pin from lower connection link and
stop link to allow installation of lower end of stabilizer.
12. Pin stabilizer in appropriate top hole according
to size of cutter bar. (Figure 8) Also refer to decal on
machine.
13. Pull out hydraulic cylinder rod (Open hydraulic
valve and release poppet in end of hydraulic line) and
assemble to connection link and stop link at lower end.
Refer to photograph and illustration for correct hole.
(Figure 9)
290 mm (11-1/2”)
215 mm (8-1/2”)
Model HM2009
Model HM2008
Model HM2007
50
Figure 9