Filter
Top Products
© 2007 ICS, Blount Inc. F/N 71537 Oct 07
TITLE 613GC SERVICE MANUAL
32
10. CYLINDER COVER
10.7 Remove stop switch leads.
10.8 Inspect cylinder cover for damage.
A Replace if necessary.
10.9 Check cylinder cover water seal and
filter cover gasket are in place and in
good condition.
A Replace if necessary.
10.10 Reassemble stop switch leads.
10.11 Make sure carburetor screw boot is in
place.
10.12 Lubricate compensating tube and fuel
tank breather tube with soapy water,
guide through cylinder cover (Install
compensating tube first).
NOTE: Be careful as to not pull
tubes away from their point of
connection. Approximately 3/4”
of tube should protrude from
cylinder cover.