Filter
Top Products
Step
13.
-
'art
to
remove
Rotor
Descrlptlon
Remarks
(1) Take off the through bolt.
Apply a box wrench on the head of
through bolt. Hit the wrench handle with
a hammer counter-clockwise to loosen.
Fig.
10-21
(2) Put the engine on the working table
recoil starter side down.
(3)
Use a bolt and oil as a tool for pulling
out rotor in the following procedures
:
1.
Pour engine oil
into
the center hole of
rotor shaft.
Fill with oil to the shaft end.
(See
Fig. 10-22.)
thread size
:
M8
X
P
1.25
the tip of the bolt.
(See Fig.
10-23.)
2. Prepare a bolt with the following
3.
Apply a few turns
of
seal tape around
Fig.
10-22
Tool
Box wrench
Plastic hammer
I
Fig.
10-23
-
39
-