Filter
Top Products
9-6
OIL
SENSOR (OPTION)
1.
Disconnect two
(2)
wires comming from the sen-
sor at the connection.
2.
Loosen the sensor to remove it from the engine.
3.
Plug the opening of oil filler hole (created after
sensor
is
removed) with suitable means such as oil
gauge.
4. Connect the removed wires again with the oil
sensor.
5.
Start the engine with the oil sensor removed and
confirm if;
a. Engine stops after
5
seconds which
is
normal, or
~~ ~
Fig.
9-9
b.
Engine does not stop after more than
10
seconds which
is
unusual.
NOTE
:
The sensor will not operate properly when wire is broken or poorly connected.
Check the wires for correct connection.
If
it fails to stop within
5
seconds after the wirings have checked, the sensor
is
wrong.
Replace the sensor with new one.
10.
DISASSEMBLY
AND
ASSEMBLY
10-1
PREPARATION
and
PRECAUTIONS
1)
Be
sure to memorize the location of individual parts when disassembling the generator so that the
generator can be reassembled correctly.. Tag the disassembled part with the necessary information to
facilitate easier and smoother reassembling.
2)
For more convenience, divide the parts into several groups and store them in boxes.
3)
To
prevent bolts and nuts from being misplaced or installed incorrectly, place them temporarily back
at their original position.
4)
Handle disassembled parts with care; clean them before reassembly using a neutral cleaning fluid.
5)
Use all disassembly /assembly tools properly, and use the proper tool for each specific job.
-
31
-